PS1 and PS2 Sensor Assembly Removal

Figure 6-51 Removing the PS1/PS2 Sensor Assembly

The PS1 and PS2 sensors are located under the Paper Feed Assembly.

1 Remove the Paper Feed Assembly and place it on a flat surface, with the MP Tray side down.

N o t e

You need not remove the MP Tray from the Paper

 

Feed Assembly. Use a cloth to protect the MP

 

Tray door from scratches.

2 Remove the PC Tray Pickup Roller.

3 Disconnect blue-wired connector on the bottom, (callout 1).

4 Remove the center pin from the dowel post.

5 Flex the right side of the Sensor Assembly to clear the locator pin and the sensor arm from the sheet metal (see Figure 6-51 callout 2).

6 As you flex the right side of the assembly, carefully release the

(2)plastic retaining tabs on the left (Figure 6-51 callout 2). 7 Slide the Assembly to the right to clear the mounts.

N o t e

When installing the Sensor Assembly, ensure the

 

sensor flags are free through their entire range of

 

travel.

6-61 Removal and Replacement