Table 7-2

Clearable Warning Messages

 

 

 

 

Message Displayed

Meaning

 

 

 

 

W1

IMAGE ADAPT

 

The printer received a graphics print file that was too

 

 

 

complex to print at the requested resolution. The printer

MEMORY LOW, PAGE

 

automatically processed the file in the highest resolution

SIMPLIFIED

 

possible with the memory installed. Add additional memory

 

 

 

to print the file at full resolution. Check the printout for loss

 

 

 

of data or print quality.

 

 

 

 

W2

INVALID PERS

 

The job was not printed because the requested personality,

 

 

 

such as PostScript, was not installed. Install the language in

REQUESTED LANGUAGE

which the files are sent, together with enough memory to

NOT AVAILABLE

 

support that language.

 

 

 

 

W3

JOB ABORTED

 

The printer was forced to abort the print job because there

INSUFFICIENT MEMORY

was not enough installed memory to support the printer

JOB CLEARED

 

language used.

 

 

 

 

W4

JOB 300/OFF

 

The job was printed at 300 dpi with page protection set as

W5

JOB 300/LTR

 

specified in the message. To print the job as requested,

W6

JOB 300/A4

 

install additional memory.

W7

JOB 300/LGL

 

 

 

 

 

 

W8

JOB 600/OFF

 

The job was printed at 600 dpi with page protection set as

W9

JOB 600/LTR

 

specified in the message. To print the job as requested,

W0

JOB 600/A4

 

install additional memory.

 

 

 

WM MEM CNFIG N/A

 

The printer did not have enough memory when switched on

 

 

 

to support the previous settings for I/O buffering and /or

MEMORY SETTINGS

 

Resource Saving, probably because you removed a

CHANGED

 

memory SIMM, added a new personality SIMM, or added

 

 

 

the optional duplex unit.

 

 

 

WM CHK MEM CNFIG

 

I/O Buffering and /or Resource Saving settings were altered

 

 

 

when the printer was switched on because the printer did

MEMORY SETTINGS

 

not have enough memory. This usually occurs after memory

CHANGED

 

has been removed from the printer. (You can check settings

 

 

 

by printing a self test.)

 

 

 

WM [personality]

 

The Resource Saving memory area for the specified

MEM FULL

 

personality is full. Press [CONTINUE]* to continue printing

 

 

 

(some data will be lost). The current job will print, but some

[personality]

 

resources (downloaded fonts, etc.) may not be saved. If this

MEMORY FULL

 

error occurs frequently, you may need to adjust Resource

 

 

 

Saving settings.

 

 

 

*Press Go on the LJ5.

 

 

Troubleshooting 7-11