Testing a SIMM Board

Use the procedures below to print a self-test page to verify SIMM board installation. Procedures are given for both memory and PostScript SIMMs.

Memory SIMM

N o t e

For the LaserJet 5/5M/5N, the On Line key has

 

been replaced by the Go key. The Enter key has

 

been replaced by the Select key.

Running a Self Test Printout

1 Plug in the power cord and turn ON the printer.

2 After a few seconds, 00 READY should appear in the control panel display. If an error message appears, refer to “Troubleshooting a SIMM Board” later in this chapter.

3 Press [On Line] to take the printer off line.

4 Press [Menu] until TEST MENU appears in the control panel display.

5 Press [Item] until SELF TEST appears in the control panel display.

6 Press [Enter] to print a self test.

7 Press [On Line] after the self test printed.

Locate “RAM SIZE” on the self-test printout. This is the amount of printer memory now installed in the printer.

Configuration 3-57