MP/PC/LC (Tray 1/2/3) LOAD Message
The conditions that result in MP/PC/LC LOAD or (TRAY 1/2/3) messages are:
•The absence of any input tray.
•The absence of media in either tray.
•The tray size switches may be defective and not recognize the presence of the paper tray. The tray is sensed as the
•The Universal Tray paper size dial setting does not match the installed paper.
The MP/PC/LC LOAD message is also generated when the user or software requests a paper size other than that installed.
The Paper Sensing Arms are located in the paper input areas of the printer. During normal operation, the Paper Sensing Arm flags rest on the media installed in the paper tray. The Sensing Arm flags are attached to shafts. The opposite end of the shaft is a photointerrupter that rotates through the sensors on the Paper Control PCA. These sensors are:
•PS4 Paper
•PS2 Paper
•PS6 Paper
•PS7 Paper
The presence of paper in the paper tray is sensed by the paper sensor arm. When paper is in the cassette, the sensor arm rests on top of the paper in the tray. At this point, the sensors are not blocked. When the tray is empty, the arm swings through its travel. The photointerrupter attached to the paper sensor arm shaft rotates and blocks the sensor diode.
Troubleshooting