N o t e

Access the Interconnect PCA Housing by laying

 

the printer on the rear of the printer chassis.

 

 

 

 

Figure 6-59 Interconnect PCA latches and AC Connector Mounting Pins

4 Disconnect the Interconnect Cable connector from the DC Controller (J210 on LJ4, J213 on LJ4+/5). Remove the cable from its retainer.

5 Release the bottom or rear-most latch (see Figure 6-59), callout 1) holding the arm of the Interconnect PCA housing to the sheet metal.

6 Rotate the bottom (rear) of the PCA housing up (toward the front) to release the housing from the printer.

(continued on next page)

6-70 Removal and Replacement