HP HyperFabric manual Deconfiguring HMP for Local Failover support Using, Sam

Configuring HyperFabric

Configuring HMP for Transparent Local Failover Support

		of adapters clic0 and clic1 and if the Card-Pair 1, comprises of
		adapters clic2 and clic3, then the following entries are added to the
		clic_global_conf file.
		CARD_PAIR[0] = clic0-clic1
		CARD_PAIR[1] = clic2-clic3
		If you press Cancel, you remain in the main “HyperFabric
		Configuration” screen.
		If you press Help, help text for this task appears.
Step	6. Exit SAM.
NOTE		To view the card pair information from the
		/etc/rc.config.d/clic_global_conf file, select “View Local
		Failover for HMP...” option in the “HyperFabric Configuration” screen.

		Deconfiguring HMP for Local Failover support - Using
		SAM
		To use SAM to deconfigure HMP for Local Failover support, complete the
		following steps:
Step	1.	Start SAM.
Step	2.	Select the “Networking and Communications” area.
Step	3.	Select “HyperFabric”.
		All HyperFabric adapter card pairs installed in the system are listed.
Step	4.	Pull down the “Actions” menu and select Deconfigure Local Failover
		for HMP to remove all the card pair entries from the
		/etc/rc.config.d/clic_global_conf file. In the next confirmation
		window that pops-up, select YES to confirm it.
		If you select NO. you remain in the main “HyperFabric Configuration”
		screen.
Step	5.	Exit SAM.

Chapter 4 103