HP HyperFabric manual

Managing HyperFabric

Stopping HyperFabric

		Using SAM
		To use SAM to stop HyperFabric on a local HP 9000 system running
		HP-UX 11i v2, complete the following steps:
Step	1.	Start SAM.
Step	2.	Select the “Networking and Communications” area.
Step	3.	Select “HyperFabric.”
Step	4.	Pull down the “Actions” menu and select Stop HyperFabric. Note that if
		HyperFabric is not running on the system, Stop HyperFabric is grayed
		out and you cannot select it.
		When HyperFabric stops, a confirmation message displays. Also, the
		status “HyperFabric: Not running” is displayed above the adapter
		configuration area of the screen.
Step	5.	Exit SAM.

Chapter 5 129