
|
| Installing HyperFabric |
|
| Installing the Software |
|
| Loading the Software |
|
| Listed below are the steps you must follow to load the HyperFabric |
|
| software, using the |
Step | 1. | Log on to the system as root. |
Step | 2. | Insert the software media into the appropriate drive. If the software is |
|
| being loaded from a |
Step | 3. | Mount the |
|
| command prompt: |
|
| $ mount device_name |
|
| where device_name is the name assigned to the |
Step | 4. | Run the swinstall program using the following command: |
|
| $ /usr/sbin/swinstall |
|
| This opens the “Software Selection” window. |
Step | 5. | Change the Source Host Name, if necessary, and then enter the mount |
|
| point of the drive in the Source Depot Path field. Select the OK button to |
|
| return to the “Software Selection” window. |
|
| The “Software Selection” window now contains a list of available |
|
| software to install. |
Step | 6. | Highlight the HyperFabric software: |
|
| • |
Step | 7. | Choose Mark for Install from the “Actions” menu; this chooses the |
|
| highlighted software. |
Step | 8. | From the “Actions” menu, select the “Install...” menu, and then choose |
|
| Install. This begins product installation and opens the “Install |
|
| Analysis” window. |
Step | 9. | Select the OK button in the “Install Analysis” window when the Status |
|
| field displays a “Ready” message. |
Step 10. Select the YES button in the “Confirmation” window to start software installation.
Chapter 3 | 55 |