HP HyperFabric manual Displaying Status and Statistics, Clicstat Command

Managing HyperFabric

Displaying Status and Statistics

Displaying Status and Statistics

You can get the status of and statistics associated with many of the HyperFabric components by using the clic_stat command, which is described below.

The clic_stat Command

The following list contains some of the information that the clic_stat command provides:

•The current fabric map, in textual format.

•The status of one or more HyperFabric adapters.

•The global configuration information for each HyperFabric adapter and switch (if the fabric contains switches). The information includes the firmware type (8-bit or 32-bit), which is used for interoperability purposes.

•The card pair information, if you configure HyperFabric in the local failover mode (applicable to applications using HMP).

The clic_stat command can also be used to enable or disable performance statistics gathering for the DLPI driver, the firmware and HMP.

All of the statistics that can be displayed using the clic_stat command are documented in the clic_stat (1M) man page on HP-UX 11.0 and on later HP-UX releases.

If you include /opt/clic/bin in your PATH statement, you can run the command as it is shown below. Otherwise, you must include /opt/clic/bin as part of the command name (that is, /opt/clic/bin/clic_stat).

To use some of this command’s parameters, you must be logged in as root (see each parameter’s description below).

The syntax is as follows:

clic_stat [-pperf_level] [-ddisplay_level] [-cadapter_ID]

[-n nodename] [-?]

Chapter 5 117