Configuring HyperFabric

Configuration Overview

IMPORTANT

In this file, clic_init and SAM add some HyperFabric-related lines

 

 

that end with the characters #clic. These lines are used by the

 

 

HyperFabric software — and are not comments — so do not remove

 

 

them from the file.

 

The system /etc/rc.config.d/clic_global_conf file.

 

 

• The /etc/rarpd.conf (Reverse Address Resolution Protocol

 

 

[RARP]) support file. This file is used in the management of the

 

 

HyperFabric switches (if you are going to enable switch

 

 

management).

The clic_init command is described in “Using the clic_init Command” on page 79. Using SAM to configure an adapter is described in “Using SAM” on page 81.

After you have used the clic_init command or SAM, you can configure HyperFabric with ServiceGuard, if necessary. For more information, see “Configuring HyperFabric with ServiceGuard” on page 87.

You can configure card pairs for the Transparent Local Failover Feature of HMP available with the B.11.23.01 release of HyperFabric. For more information, see “Configuring HMP for Transparent Local Failover Support” on page 96.

70

Chapter 4

Page 84
Image 84
HP HyperFabric manual That end with the characters #clic. These lines are used by