Troubleshooting HyperFabric

Replacing a HyperFabric Switch

 

 

Replacing a HyperFabric Switch

 

 

If you need to replace a faulty HyperFabric switch, follow these steps:

Step

1.

If you do not have an HA environment, stop HyperFabric on all nodes

 

 

that are connected to the faulty switch. (See “Stopping HyperFabric” on

 

 

page 128.)

 

 

If you have an HA environment with two switches (where the backup

 

 

switch will have taken over when the first switch failed), disconnect all

 

 

cables attached to the faulty switch.

Step

2.

Install a new switch. (See “Installing HyperFabric Switches” on

 

 

page 57.)

Step

3.

If you stopped HyperFabric on all nodes connected to the switch (in step

 

 

1), start it on those nodes. (See “Starting HyperFabric” on page 109.)

Chapter 6

157

Page 171
Image 171
HP manual Replacing a HyperFabric Switch