HP HyperFabric manual Rack back Bracket

Installing HyperFabric

Installing HyperFabric Switches

the flat part). Otherwise, the brackets will not secure the back of the switch properly. The following figure shows the rack with these two brackets installed.

rack back

bracket 2

front		switch
	of	flanges)
(with

rack front

bracket 1

Step	6.	When you are sure the brackets are snug against the beveled part of the
		switch, tighten all four screws in brackets 1 and 2.
Step	7.	For each port that will be connected to an HyperFabric adapter in an
		HP 9000 system, attach the cable from the corresponding adapter. Your
		connections must be copper-to-copper and fiber-to-fiber (including
		cables).
Step	8.	Connect the switch to the Ethernet network.

Chapter 3 63