
Managing HyperFabric
Displaying Status and Statistics
Note that the second line in the above syntax is indented for readability purposes only. When the command is typed there should not be any indentation.
The command parameters are as follows:
•
TCP | Enables DLPI driver statistics |
| when under the TCP/IP stack. |
HMP | Enables Hyper Messaging |
| Protocol (HMP) statistics |
| gathering. |
FW | Enables firmware statistics |
| gathering. |
RST | Disables/resets the DLPI driver |
| and HMP statistics. |
Note that turning on performance statistics gathering will affect the performance of HyperFabric, by increasing CPU usage and message latency (the time it takes a message to get from one point to another). It might also decrease the throughput of data. HP recommends that you do not specify this parameter unless you are trying to troubleshoot HyperFabric problems.
You must be logged in as root to use this parameter.
•
NET | Displays fabric component |
| statistics. |
CFG | Displays the management |
| daemon (clic_mgmtd) |
| configuration and statistics data. |
VRID | Displays the virtual route |
| identifier |
| VRIDs, IP addresses, switch |
| hopcounts, and physical |
| |
| adapter in the local node. |
ALL | Displays all available status data. |
118 | Chapter 5 |