HP HyperFabric manual Etc/opt/resmon/dictionary/clic01

Installing HyperFabric

Installing the Software

The commands and files used to administer HyperFabric typically have a prefix of clic_. CLIC stands for CLuster InterConnect, and it is used to differentiate those HyperFabric commands/files from other commands/files. For example, the HyperFabric command clic_init is different from the HP-UX init command.

Each of the files shown in Figure 3-1 above is briefly described below:

•/etc/opt/resmon/dictionary/clic_01

The HyperFabric dictionary file for the Event Monitoring Service (EMS).

•/etc/rc.config.d/clic_global_conf

The global configuration file, which contains the IP addresses for each adapter and each HyperFabric switch (if any) in the fabric.

•/sbin/init.d/clic

The system boot startup script for the HyperFabric management process.

•/var/adm/clic_ip_drv.trc

One of the software’s trace files. This file is created when the clic_diag -D TCP_IP command is run.

•/var/adm/clic_ip_drv.trc0

One of the HyperFabric software’s trace files. This is the primary file that is created when the clic_diag -C TCP_IP command is run.

•/var/adm/clic_ip_drv.trc1

One of the HyperFabric software’s trace files. This file is created when the clic_diag -C TCP_IP command is run, and the primary trace file (clic_ip_drv.trc0) becomes full.

•/var/adm/clic_log

The global log file that is updated by the HyperFabric management process.

•/var/adm/clic_log.old

The backup copy of the log file that is created when the log file grows larger than 100 Kbytes.

52 Chapter 3