HP Laser CE527A#ABA manual Solve common Macintosh problems

Solve common Macintosh problems

Table 10-3Problems with Mac OS X

The printer driver is not listed in the Print Center or Printer Setup Utility.

Cause Solution

The product software might not have been installed or was installed incorrectly.

Make sure that the product .GZ file is in the following hard-drive folder:

●Mac OS X V10.3 and V10.4: Library/Printers/PPDs/ Contents/Resources/<lang>.lproj, where <lang> is the two-letter language code for the language that you are using.

●Mac OS X V10.5: Library/Printers/PPDs/Contents/ Resources

	If necessary, reinstall the software. See the getting started guide for
	instructions.
The Postscript Printer Description (PPD) file is corrupt.	Delete the .GZ file from the following hard-drive folder:
	● Mac OS X V10.3 and V10.4: Library/Printers/PPDs/
	Contents/Resources/<lang>.lproj, where <lang> is the
	two-letter language code for the language that you are using.
	● Mac OS X V10.5: Library/Printers/PPDs/Contents/
	Resources
	Reinstall the software. See the getting started guide for instructions.

The product name, IP address, or Rendezvous/Bonjour host name does not appear in the product list in the Print Center or Printer Setup Utility.

Cause Solution

The product might not be ready.

Make sure that the cables are connected correctly, the product is on, and the Ready light is on. If you are connecting through a USB or Ethernet hub, try connecting directly to the computer or use a different port.

The wrong connection type might be selected.

Make sure that USB, IP Printing, or Rendezvous/Bonjour is selected, depending on the type of connection that exists between the product and the computer.

The wrong product name, IP address, or Rendezvous/Bonjour host name is being used.

Print a configuration page to check the product name, IP address, or Rendezvous host name. Verify that the name, IP address, or Rendezvous host name on the configuration page matches the product name, IP address, or Rendezvous host name in the Print Center or Printer Setup Utility.

The interface cable might be defective or of poor quality. Replace the cable with a high-quality cable.

The printer driver does not automatically set up your selected product in the Print Center or Printer Setup Utility.

Cause Solution

The product might not be ready.

Make sure that the cables are connected correctly, the product is on, and the Ready light is on. If you are connecting through a USB or Ethernet hub, try connecting directly to the computer or use a different port.

ENWW Solve common Macintosh problems 195