HP Laser CE527A#ABA Solve connectivity problems, Solve direct-connect problems, Problem Solution

Solve connectivity problems

Solve direct-connect problems

If you have connected the product directly to a computer, check the cable.

●Verify that the cable is connected to the computer and to the product.

●Verify that the cable is not longer than 2 meters (6 feet). Replace the cable if necessary.

●Verify that the cable is working correctly by connecting it to another product. Replace the cable if necessary.

Solve network problems

Check the following items to verify that the product is communicating with the network. Before beginning, print a configuration page. See Print the information and show-me-how pages on page 108.

Problem	Solution
Poor physical connection	Verify that the product is attached to the correct network port using a cable of the
	correct length.
	Verify that cable connections are secure.
	Look at the network port connection on the back of the product, and verify that the
	amber activity light and the green link-status light are lit.
	If the problem continues, try a different cable or port on the hub.
The computer is unable to communicate	Use the command prompt to ping the product from your computer. For example:
with the product.	ping 192.168.45.39
	Verify that the ping displays round-trip times, which indicates that it is working.
	If the ping command failed, verify that the network hubs are on, and then verify that
	the network settings, the product, and the computer are all configured for the same
	network.
Incorrect link and duplex settings	Hewlett-Packard recommends leaving this setting in automatic mode (the default
	setting). See Link speed and duplex settings on page 71.
Incorrect IP address for the product on	Use the correct IP address.
the computer	If the IP address is correct, delete the product and then it add again.
New software programs have caused	Verify that any new software programs are correctly installed and that they use the
compatibility problems.	correct printer driver.
Your computer or workstation is set up	Check the network drivers, printer drivers, and the network redirection.
incorrectly.	Verify that the operating system is configured correctly.
The protocol is disabled, or other	Print a configuration page to check the status of the protocol. Enable it if necessary.
network settings are incorrect.	Use the control panel to reconfigure the network settings if necessary.

190 Chapter 10 Solve problems ENWW