HP Laser CE527A#ABA manual Ping Test, Dest Type IPV4, Dest IPV4, Dest IPV6, Packet Size, Count

Item	Sub-item	Sub-item	Values	Description
	PING TEST			Check network communications. This test
				sends link-level packets to a remote network
				host, then waits for an appropriate response.
				To run a ping test, set the following items:
		DEST TYPE	IPV4	Specify whether the target product is an IPv4
			IPV6	or IPv6 node.
		DEST IPV4		Type the IPv4 address.
		DEST IPV6		Type the IPv6 address.
		PACKET SIZE		Specify the size of each packet, in bytes, to
				be sent to the remote host. The minimum is
				64 (default) and the maximum is 2048.
		TIMEOUT		Specify the length of time, in seconds, to wait
				for a response from the remote host. The
				default is 1 and the maximum is 100.
		COUNT		Specify the number of ping test packets to
				send for this test. Select a value from 0 to 100.
				The default is 4. To configure the test to run
				continuously, select 0.
		PRINT RESULTS	YES	If the ping test was not set for continuous
			NO*	operation, you can print the test results.
		EXECUTE	YES	Specify whether to initiate the ping test.
			NO*
	PING RESULTS			View the ping test status and results on the
				control panel display. You can select the
				following items:
		PACKETS SENT		Shows the number of packets (0 - 65535)
				sent to the remote host since the most recent
				test was initiated or completed. The default is
				0.
		PACKETS		Shows the number of packets (0 - 65535)
		RECEIVED		received from the remote host since the most
				recent test was initiated or completed. The
				default is 0.
		PERCENT LOST		Shows the percent (0 to 100) of ping test
				packets that were sent with no response from
				the remote host since the most recent test
				was initiated or completed. The default is 0.
		RTT MIN		Shows the minimum detected round-trip-
				time (RTT), from 0 to 4096 milliseconds, for
				packet transmission and response. The
				default is 0.
		RTT MAX		Shows the maximum detected round-trip-
				time (RTT), from 0 to 4096 milliseconds, for
				packet transmission and response. The
				default is 0.

ENWW Configure device menu 35