HP Laser CE527A#ABA manual Resets menu, RTT Average, Ping YES, Progress, Refresh YES

Item	Sub-item	Sub-item	Values	Description
		RTT AVERAGE		Shows the average round-trip-time (RTT),
				from 0 to 4096 milliseconds, for packet
				transmission and response. The default is 0.
		PING IN	YES	Select whether the control panel indicates
		PROGRESS	NO*	when a ping test is in progress.
		REFRESH	YES	When viewing the ping test results, this item
			NO*	updates the ping test data with current
				results. A refresh automatically occurs when
				the menu times out or you manually return to
				the main menu.

LINK SPEED	AUTO*
	10T HALF
	10T FULL
	100TX HALF
	100TX FULL
	100TX AUTO
	1000TX FULL

The link speed and communication mode of the print server must match the network. The available settings depend on the product and installed print server.

CAUTION: If you change the link setting, network communications with the print server and network product might be lost.

AUTO: The print server uses auto- negotiation to configure itself with the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10T HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.)

10T HALF: 10 Mbps, half-duplex operation.

10T FULL: 10 Mbps, full-duplex operation.

100TX HALF: 100 Mbps, half-duplex operation.

100TX FULL: 100 Mbps, full-duplex operation.

100TX AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.

1000TX FULL: 1000 Mbps, full-duplex operation.

Resets menu

Use the RESETS menu to reset factory settings, disable and enable sleep mode, and update the product after new supplies are installed.

To display: Press the Menu button , select the CONFIGURE DEVICE menu, and then select the RESETS menu.

NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no default.

36 Chapter 2 Control panel ENWW