Setup
WebQoS setup Script (UNIX)
under the directory you specify.
After the script finishes, start your web server(s).
Server 3 Setup
On server3, you are running the SCI. You must identify server 1 as the system on which the database is running. When you run the setup script on server 3, you must provide the following information:
•Continue?
Enter y or hit Enter to continue. If you do not want to run WebQoS or read the software license terms, enter n to exit the script now.
•Do you accept the HP Software License Terms?
If you accept the software license terms and want to continue running the setup script, enter y. Otherwise, enter n to exit the script.
•Would you like to create the WebQoS database on this system?
Enter n. The database has been created on server 1.
•Please configure the name of the system where the database runs.
Enter the name of server 1.
•Enter the database password:
Enter the password for the WebQoS database on server 1. If you have forgotten the password, you must recreate the database.
•Would you like to enable the SCO?
Enter n. You are not running the SCO on this server.
•Would you like to enable the SCI?
Enter y. You are running the SCI on this server.
•Root pathname of Netscape server.
Enter NONE. You do not want to configure any web servers.
Note that you were not asked to enter a management console password. The password was configured when you ran the setup script on server 1 and stored in the database.
36 | Chapter 2 |
