Replacing the bezels
The left bezel contains the LEDs; the right bezel contains the hard disk drive identification information. See the illustrations in “Disk drives and bezels” on page 7.
Removing the bezels
Left bezel
Right bezel
Handles
Figure 57. Removing the bezels
To remove either the left or right bezel, complete the following steps:
1.If the DS3200 is on a table or other flat surface, elevate the DS3200 front slightly or extend the front over the table edge.
2.Grasp the handle on the front of the bezel and pull until the bezel is clear of the bottom tab on the chassis flange.
3.Lift the bezel off the chassis flange.
Installing the bezels
To install either the left or right bezel, complete the following steps:
1.Fit the cutout that is on the top of the bezel over the tab on the chassis flange.
2.Rotate the bezel down until it snaps into place. Make sure that the inside surface of the bezel is flush with the chassis.
