The following illustration shows a drive compatibility key.

Tab

Figure 60. Drive compatibility key

To replace a drive compatibility key, complete the following steps:

1.Read the safety information that begins on page xi and “Best practices guidelines” on page 6.

2.Turn off the DS3200, or wait until the DS3200 is shut down for maintenance.

3.Remove the three hard disk drives that are in the column of bays that contain the broken drive compatibility key. See “Removing a hard disk drive” on page 74.

4.Remove the broken drive compatibility key:

a.Flex the rear of the key slightly toward the middle of the bay to release it from the tab that holds it.

b.Slide the key toward the front of the bay until it is released from the chassis.

Correct key tab position

Bay tab

Guides

Key tab

Figure 61. Installing a drive compatibility key

5.Install the replacement drive compatibility key:

a.Orient the key as shown in the illustration.

b.Place the key between the drive guides in the left wall of the bay, flush with the wall.

c.Slide the key tab under the metal tab that is on the left wall of the bay; then, slide the key toward the rear of the chassis until the key stops (the key is

96System Storage DS3200 Storage Subsystem: Installation, User’s, and Maintenance Guide

Page 114
Image 114
IBM DS3200 Storage Subsystem manual Following illustration shows a drive compatibility key