Bezel (left side)
The left bezel contains the DS3200 LEDs, as shown in the following illustration. For a description of the LEDs, see “Front LEDs” on page 53.
System locator LED
Overtemperature LED
System error LED
Figure 3. Bezel (left side)
Bezel (right side)
The right bezel contains the hard disk drive identification information, as shown in the following illustration.
Drives 1 - 4
Drives 5 - 8
Drives 9 - 12
Figure 4. Bezel (right side)
The DS3200 supports up to twelve 3 Gbps SAS or SATA hard disk drives, which come preinstalled in drive trays. Install drives in the 12 drive bays on the front of the storage subsystem. When a drive is installed, the drive and tray bay designation is set automatically. The hardware addresses are based on the enclosure ID setting on the controller and on the physical locations of the drives in the storage subsystem.
There are no serviceable parts in a drive assembly. If it fails, it must be replaced in its entirety (drive, bezel, and tray). When you replace a drive, be sure to order and install the correct drive. Using a nonsupported drive causes the drive to be locked out by the DS3200 controller firmware.
8System Storage DS3200 Storage Subsystem: Installation, User’s, and Maintenance Guide
