IBM Partner Pavilion DS4100 manual Connecting the power cord to the AC power connector

Statement 8:

CAUTION:

Never remove the cover on a power supply or any part that has the following label attached.

Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.

1.Ensure that the ac power switch is off on the power supply that you are installing.

2.Install the power supply in the storage server, as follows:

a.Slide the power supply into the storage server. Make sure that the lever is pulled straight out as you slide the power supply into the storage server.

b.Close the lever until the pull-ring latch locks in place. Make sure that the lever locks into place in the storage-server chassis.

3.Wrap the strain-relief clamp around the power cord approximately 20 cm (8 in.) from the power-supply connection end. Leave some slack between the clamp and the power-supply end of the power cord.

4.Replace the power-supply nut and tighten it securely to secure the clamp to the power supply unit.

5.Connect the power cord to the AC power connector. See Figure 69.

Lever

AC power	Strain-relief-	AC power
connector	clamp	switch

f10ug027

Figure 69. Connecting the power cord to the AC power connector

6.Plug the power cord into a properly grounded electrical outlet.

7.Turn on the power-supply switch.

8.DS4100 single-controller storage server only: If you have replaced a working (non-failed) power supply on a DS4100 single-controller storage server, turn on

Chapter 5. Installing and replacing components 93