Integra DHC-9.9 instruction manual 105

Advanced Setup—Continued

4

Enter

Enter

Use the Up and Down [q]/[w] but- tons to select “Subwoofer”, and then use the Left and Right [e]/[r] buttons to select:

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

8	Use the Up and Down [q]/[w] but-
	tons to select “SurrBack”, and
	then use the Left and Right
Enter	[e]/[r] buttons to select a cross-
	over frequency.
	If no surround back speakers are con-
	nected, select “None”.
	Notes:
Enter	• Cannot be set if “Speaker Type” is
	set to “Bi-Amp” (page 55), “Sur-
	round” is set to “None” (step 7).
	• Cannot select “Full Band” if “Sur-
	round” (step 7) is set to anything

5	Use the Up and Down [q]/[w] but-
	tons to select “Front”, and then
	use the Left and Right [e]/[r]
Enter	buttons to select a crossover fre-
	quency.
	Note:
	Fixed at “Full Band” if “Subwoofer”
	(step 4) is set to “No”.
Enter

	other than “Full Band”.
9	Use the Up and Down [q]/[w] but-
	tons to select “SurrBack Ch”,
	and then use the Left and Right
Enter	[e]/[r] buttons to select:
	1ch: Select if one surround back
	speaker is connected.
	2ch: Select if two (left and right)
	surround back speakers are
Enter	connected.
	Note:
	Cannot be set if “Speaker Type” is set

6

Enter

Enter

Use the Up and Down [q]/[w] but- tons to select “Center”, and then use the Left and Right [e]/[r] buttons to select a crossover fre- quency.

If no center speaker is connected, select None.

Note:

Cannot select “Full Band” if “Front” (step 5) is set to anything other than “Full Band”.

to “Bi-Amp” (page 55), “SurrBack” is

set to “None” (step 8).

Continue with step 10 on the next page.

7

Enter

Enter

Use the Up and Down [q]/[w] but- tons to select “Surround”, and then use the Left and Right [e]/[r] buttons to select a cross- over frequency.

If no surround left and right speakers are connected, select “None”.

Note:

Cannot select “Full Band” if “Front” (step 5) is set to anything other than “Full Band”.

105