Integra DHC-9.9 Using the Sleep Timer, Adjusting the Bass & Treble, Using Headphones

Basic Operations—Continued

Using the Sleep Timer

With the sleep timer, you can set the AV controller to turn off automatically after a specified period.

Adjusting the Bass & Treble

You can adjust the bass and treble for the front speakers, except when the Direct or THX listening mode is selected.

Receiver

Press the [Receiver] button, and then press the [Sleep] button repeatedly to select the required

1	Press the AV controller’s [Tone]
	button repeatedly to select Bass
	or Treble for Front, Center, Sur-

Sleep sleep time.

The sleep time can be set from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set. The specified sleep time appears on the display for about five seconds, then the previous display reappears.

If you need to cancel the sleep timer, press the [Sleep] button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV controller sleeps, press the [Sleep] button. Note that if you press the [Sleep] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

Using Headphones

For private listening, you can connect a pair of stereo headphones (1/4-inch phone plug) to the AV controller’s Phones jack.

Notes:

•Always turn down the volume before connecting your headphones.

•While the headphones plug is inserted in the Phones jack, the speakers are turned off and the Headphone indicator lights up.

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, or Direct.

•Only the Stereo, Direct, and Mono listening modes can be used with headphones (the listening modes available also depend on the currently selected input source).

•When the multichannel input is used, only the front left and right audio can be heard in the headphones.

	round, SurrBack, or Subwoofer.
2	Use the Tone Plus [+] and Minus
	[–] buttons to adjust.

■Bass

You can boost or cut low-frequency sounds output by the front speakers from –10 dB to +10 dB in 1 dB steps.

■Treble

You can boost or cut high-frequency sounds output by the front speakers from –10 dB to +10 dB in 1 dB steps.

Notes:

•This setting is not available when the multichannel Analog input is selected.

•The tone control settings do not apply to the Direct, or THX listening modes.

Displaying Source Information

You can display various information about the current input source as follows.

Remote	Press the [Display] button
controller	repeatedly to cycle through the
Display	available information.
AV controller

The following information can typically be displayed:

Input source

Listening mode

Signal format*

Sampling frequency

*If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format and the number of channels is displayed. For some digital input sig- nals, including multichannel PCM, the signal format, number of channels, and sampling frequency is displayed.

Information is displayed for about three seconds, then the previ- ously displayed information reappears.

66