Integra DHC-9.9 Adjusting the Volume of Zones, Adjusting the Tone and Balance of Zones, Notes

Zone 2 and Zone 3—Continued

Adjusting the Volume of Zones

Adjusting the Tone and Balance of Zones

1

Remote

controller

AV controller

On the remote controller, press the [Zone2] or [Zone 3] Remote Mode button.

On the AV controller, press the [Zone 2] or [Zone 3] button.

The Zone 2 or Zone 3 indicator flashes.

1		On the AV controller, press the
	AV controller	[Zone 2] or [Zone 3] button.

2	Press the AV controller’s [Tone]
	button repeatedly to select
	“Bass” “Treble” or “Balance”.

2	On the remote controller, press
Remote	the [Level–] and [Level+] button.
controller
	On the AV controller, press Up
	[q] and Down [w] button.
AV controller

Note:

Zones can also be unmuted by adjusting the volume.

Muting Zones

On the remote controller, press the [Zone2] or [Zone 3] Remote Mode button, and then press the [Muting] button.

To unmute a zone, on the remote controller, press the [Zone2] or [Zone 3] Remote Mode button, and then press the [Muting] but- ton again.

3	Use the Tone Plus [+] and Minus
	[–] buttons to adjust the Bass,
	Treble or Balance.
	• You can boost or cut the Bass or Tre-
	ble from –10 dB to +10 dB in 2 dB
	steps.

•You can adjust the balance from 0 in the center to +10 dB to the right or +10 dB to the left in 2 dB steps.

Notes:

•The tone cannot be adjusted for Zone 3.

•The Zone 2 level, balance, and tone functions have no effect on the ZONE 2 PRE OUT when the “Zone2 Out” setting is set to “Fixed” (page 132).

•The Zone 3 level and balance functions have no effect on the ZONE 3 PRE OUT when the “Zone3 Out” set- ting is set to “Fixed” (page 132).

134