Integra DHC-9.9 instruction manual the front left speaker, Advanced Setup—Continued, Notes

Advanced Setup—Continued

2

Enter

Enter

Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [Enter].

The “Speaker Setup” menu appears.

2.Speaker Setup

1.Speaker Settings

2.Speaker Config

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

MOVE ENTER ENTER RETURN RETURN SETUP EXIT

5	Repeat step 4 until the volume of
	the test tone from each speaker
	is the same.
	If you’re using a handheld sound level
	meter, adjust the level of each speaker
	so that it reads 75 dB SPL at the listen-
	ing position, measured with C-weight-
	ing and slow reading.
6	Press the [Setup] button.
	Setup closes.
	S
	et
	u
	p

3	Use the Up and Down [q]/[w] but-
	tons to select “4. Level Calibra-
	tion”, and then press [Enter].
Enter	The “Level Calibration” screen appears
	and the pink noise test tone is output by
	the front left speaker.

Notes:

• Speaker levels can also be adjusted by using the dedi-

cated buttons on the remote controller. Press the

[Test Tone] button to output the test tone. Use the

[CH Sel] button to select each speaker, and use the

[Level–] and [Level+] buttons to adjust the level.

Enter

2–4.	Level Calibration
Left	-12.0dB
Center	-12.0dB
Right	-12.0dB
SurrRight	-12.0dB
SurrBack R	-12.0dB
SurrBack L	-12.0dB
SurrLeft	-12.0dB
Subwoofer	-15.0dB
MOVE	VALUE

RETURN RETURN SETUP EXIT

• This procedure can also be performed on the AV con-

troller by using its [Setup] button, arrow buttons, and

[Enter] button.

Note:

Levels cannot be adjusted for speakers set to “No” or “None” in the Speaker Configuration (page 104).

4	Use the Up and Down [q]/[w] but-
	tons to select a speaker, and use
	the Left and Right [e]/[r] but-
Enter	tons to adjust the level.

Levels can be adjusted from –12 to +12 dB in 0.5 dB steps (–15 to +12 dB for the subwoofer).

Notes:

•The “Center” level cannot be set if the “Center” is set to “None” (page 104).

•The “SurrRight” and “SurrLeft” lev- els cannot be set if the “Surround” is set to “None” (page 104).

•The “SurrBack R” and “SurrBack L” levels cannot be set if “Speaker Type” is set to “Bi-Amp” (page 55), “SurrBack” is set to “None” (page 104).

•The “Subwoofer” levels cannot be set if “Subwoofer” is set to “No” (page 105).

109