Integra DHC-9.9 Controlling Other Components, Entering Remote Control Codes, one that works best

Controlling Other Components

You can control your other components, including those made by other manufacturers, with the remote controller. This section explains how to:

•Enter the remote control code for a component that you want to control: DVD, TV, VCR, etc.

•Learn commands directly from another component’s remote controller (see page 140).

•Program the Macro buttons to perform a sequence of up to eight remote control actions (see page 141).

Entering Remote Control Codes

To control another component, you must first enter that component’s remote control code to a Remote Mode but- ton. You’ll need to enter a code for each component that you want to control.

							Remote
Standby	On	Standby					indicator
					TV
						Input	TV I
	DVD	VCR/DVR		CBL/SAT
Number	1		2	3		+
	Game/TV	AUX 1		AUX 2		TV CH
buttons	4		5	6		-
	Tape	Tuner		CD
	7		8	9
	Phono			D.TUN		TV VOL
	+10		0	Clear
	--/--- 10		11		12
	Input Selector
		Macro
	1		2	3		Zone3
		Remote Mode
Remote	DVD	VCR		CD		Zone2
				CDR/MD			Receiver
Mode	TV	Cable		Dock		Receiver
		SAT				Tape/AMP
	Dimmer					Sleep
			nu	Me
			Me
		op		nu
		T
	+
	CH		Enter			VOL
	Disc
	Album
	-		G
				it
	Prev		uide	Ex
		Se			n
	CH		tup	Ret
	Display					Muting
	Rec		Playlist			Random
		Listening Mode
	Stereo	Surround
	Repeat	Audio		Subtitle		Play Mode
		Direct		THX		All ST
	Test Tone	CH Sel		Level-		Level+
	Open/Close	Video Off
		Audio Sel		L Night		Re-EQ
		VCR		DVD		HDD
			RC-691M

1	Look up the component’s remote
	control code in the separate
	Remote Control Codes list.
	The codes are organized by category.

2	While holding down the Remote
	Mode button to which you want
	to enter the code, press the
	[Standby] button.
	The Remote indicator lights up.

3	Within 30 seconds, use the num-
	ber buttons to enter the 4-digit
	remote control code.
	The Remote indicator flashes twice.

4	Press the Remote Mode button
	again to select the remote con-
	troller mode, point the remote
	controller at the component, and
	check the operation.
	If the remote controller doesn’t work as
	expected, and several remote codes are
	listed, try each one in turn and use the
	one that works best.

Notes:

•Remote control codes cannot be entered for the [Receiver], [Zone 2], and [Zone 3] Remote Mode but- tons.

•The remote control codes provided are correct at the time of printing but subject to change.

•The [DVD] and [CD] Remote Mode buttons are preprogrammed for use with Integra/Onkyo DVD players and CD players, respectively.

•To control another manufacturer’s CD recorder, MD recorder or Onkyo RI Dock, enter the appro- priate remote control code to the [CD] Remote Mode button.

137