Advanced Setup—Continued

Power Control

To link the power functions of -compatible components connected via HDMI, select “Enable”.

Disable: Power Control disabled.

Enable: Power Control enabled.

Notes:

The “Power Control” setting can be set only when the above “Control” setting is set to “Enable”.

HDMI power control only works with -com- patible components that support it and may not work properly with some components due to their settings or compatibility.

When set to “Enable”, power consumption will increase.

Refer to the connected component’s instruction man- ual for details.

TV Control

Set to “Enable” when you want to control the AV con-

troller from an -compatible TV that is con- nected to HDMI.

Disable: TV Control disabled.

Network Settings

Note:

When modifying network settings, after modifying it is necessary to execute Save Settings.

This section explains how to configure the AV control- ler’s network settings manually.

If your router’s DHCP server is enabled, you don’t need to change any of these settings, as the AV controller is set use DHCP to configure itself automatically by default (i.e., DHCP is set to Enable). If, however, your router’s DHCP server is disabled, for example, you’re using static IP addresses, you’ll need to configure these set- tings yourself, in which case, a knowledge of Ethernet networking is essential.

What’s DHCP?

DHCP (Dynamic Host Configuration Protocol) is used by routers, computers, the AV controller, and other devices to automatically configure themselves on a net- work.

Enable: TV Control enabled.

Notes:

• Set to “Disable” when the TV is not compatible or

when it is unclear whether the TV is compatible or

not.

• The “TV Control” setting can be set only when the

above “Control” and “Power Control” settings are both

set to “Enable”.

• Refer to the connected component’s instruction man-

ual for details.

1

Receiver

Setup

Press the [Receiver] Remote Mode button, followed by the [Setup] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

Note:

After changing the settings of the “Control”, “Power

Control”, or “TV Control”, turn off the power to all

connected pieces of equipment and then turn on

again. Refer to the User’s Manuals for all connected

pieces of equipment.

When linking to a TV that conforms to the CEC

standard, the “Monitor Out” setting must be set to

“HDMI Main”.

2

Enter

Enter

Use the Up and Down [q]/[w] but- tons to select “7. Hardware Setup”, and then press [Enter].

The “Hardware Setup” menu appears.

7.Hardware Setup

1.Remote Control

2.Zone2/Zone3

3.Tuner

4.Analog Multich

5.HDMI

6.Network

MOVE

ENTER

ENTER

RETURN

RETURN

SETUP

EXIT

 

 

 

 

 

 

 

127

Page 127
Image 127
Integra DHC-9.9 instruction manual 127, Network Settings