Integra DHC-9.9 instruction manual 111

Advanced Setup—Continued

■MultEQ XT

Audyssey MultEQ XT correction is active (see page 58).

■Dynamic EQ

“Audyssey MultEQ XT” and “Dynamic EQ” becomes active (see page 58).

■Dynamic Vol(Light)

“Audyssey MultEQ XT”, “Dynamic EQ”, and “Dynamic Volume (Light Compression Mode)” becomes active (see page 58).

This setting prevents loud and soft sounds from being much louder and softer respectively than average sounds.

■Dynamic Vol(Heavy)

“Audyssey MultEQ XT”, “Dynamic EQ”, and “Dynamic Volume (Heavy Compression Mode)” becomes active (see page 58).

6

Enter

Enter

Use the Up and Down [q]/[w] but- tons to select a frequency, and then use the Left and Right [e]/[r] buttons to adjust the level at that frequency.

You can select: “25Hz”, “40Hz”, “63Hz”, “100Hz”, “160Hz”, “250Hz”, “400Hz”, “630Hz”, “1000Hz”, “1600Hz”, “2500Hz”, “4000Hz”, “6300Hz”, “10000Hz”, or “16000Hz”. And for the subwoofer, “25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.

The volume at each frequency can be adjusted from –6 to +6 dB in 1 dB steps.

This setting affects volume the most, causing all sounds to be of equal loudness.

5	Use the Down [w] button to select
	“Channel”, and then use the Left
	and Right [e]/[r] buttons to
Enter	select a speaker.
	You can select: “Front”, “Center”,
	“Surround”, “SurrBack”, or “Sub-
	woofer”.
Enter	2–5.	Equalizer Settings
	Equalizer		Manual
	Channel		Front
	25Hz		0dB
	40Hz		0dB
	63Hz		0dB
	100Hz		0dB
	160Hz		0dB
	250Hz		0dB
	400Hz		0dB
	MOVE	VALUE	RETURN RETURN SETUP EXIT

	Tip:
	Low frequencies (e.g., 160Hz) affect
	bass sounds; high frequencies (e.g.,
	6300Hz) affect treble sounds.
7	Use the Up and Down [q]/[w] but-
	tons to select “Channel”, and
	then use the Left and Right
Enter	[e]/[r] buttons to select another
	speaker.
	Repeat steps 6 and 7 for each speaker.
Enter

8	Press the [Setup] button.
	The setup menu closes.
	S
	et
	u
	p

Notes:

•When the listening mode is set to Direct, no effect will be produced.

•The Equalizer settings have no effect on 176.4/ 192 kHz input signals.

•This procedure can also be performed on the AV con- troller by using its [Setup] button, arrow buttons, and

[Enter] button.

111