Integra DHC-9.9 Error Messages, First Time Setup—Continued, Ambient noise is too high

First Time Setup—Continued

Error Messages

While the automatic speaker setup is in progress, one of the following error messages may appear:

❑Ambient noise is too high

Auto Speaker Setup

Retry

Cancel

!Ambient noise is too high.

MOVE ENTER ENTER

This message appears if the background noise is too loud and the measurements cannot be performed properly.

Remove the source of the noise and try again.

Retry: Return to the measured point immediately before and start set up again.

Cancel: Cancel the automatic speaker setup.

❑Speaker Detect Error

Auto Speaker Setup
Next
Cancel
:Yes	:No
:---	!
	:Error
!	Speaker Detect Error
MOVE	ENTER ENTER

This message appears if a speaker is not detected. “Yes” means that a speaker was detected. “No” means that no speaker was detected. Check your speaker connections and retry, or cancel the automatic speaker setup.

Auto Speaker Setup
Next
Cancel
:Yes	:No
:---	!
	:Error
!	Speaker Detect Error
MOVE	ENTER ENTER

The front right speaker has not been detected.

Auto Speaker Setup
Next
Cancel
:Yes	:No
:---	!
	:Error
!	Speaker Detect Error
MOVE	ENTER ENTER

The surround right speaker has not been detected.

Auto Speaker Setup
Next
Cancel
:Yes	:No
:---	!
	:Error
!	Speaker Detect Error
MOVE	ENTER ENTER

The surround back left speaker has not been detected.

Auto Speaker Setup
Next
Cancel
	!
:Yes	:No
:---	!
	:Error
!	Speaker Detect Error
MOVE	ENTER ENTER

There is a problem with the front left speaker. If the warning triangle ( ) appears for the subwoofer, it may be that the output from the subwoofer is too loud.

Auto Speaker Setup
Retry
Cancel
!	Speaker Detect Error
MOVE	ENTER ENTER

The number of speakers detected on the second or third measurement was different to the number detected on the first measurement.

Make sure speakers that cannot be detected are con- nected property.

Retry: Return to step 2 and try again. Cancel: Cancel the automatic speaker setup.

❑Writing Error!

Auto Speaker Setup
Retry
Cancel
!	Writing Error!
MOVE	ENTER ENTER

This message appears if saving fails.

Try saving again. If this message appears after 2 or 3 attempts, the AV controller is probably malfunctioning. Contact your Onkyo dealer.

Retry: Return to step 2 and try again. Cancel: Cancel the automatic speaker setup.

62