Intel SE7520JR2 manual MBMC Sensor Support, Alert over LAN, PEF Action Priorities

Intel® Server Board SE7520JR2 Platform Management

down, power cycle, and/or reset actions, the actions are performed according to PEF Action Priorities.

Note: An action that has changed from delayed to non-delayed, or an action whose delay time has been reduced automatically has higher priority. The mBMC can be configured to log PEF actions as SEL events.

Table 54: PEF Action Priorities

Action	Priority	Delayed	Type	Note
Power-Down	1	Yes	PEF Action
Soft-shutdown	2	Yes	OEM PEF Action	Not executed if a power-down action was
				also selected
Power cycle	3	Yes	PEF Action	Not executed if a power-down action was
				also selected
Reset	4	Yes	PEF Action	Not executed if a power-down action was
				also selected
Diagnostic Interrupt	5	No	PEF Action	Not executed if a power-down action was
				also selected
PET Alert	6	No	PEF Action	When selected, always occurs immediately
				after detection of a critical event.
Sensor feedback	7	No	OEM PEF Action	When selected, always occurs immediately
				after detection of a critical event.
IPMB message event	8	No	OEM PEF Action	When selected, always occurs immediately
				after detection of a critical event.
Fault LED action	9	No	OEM PEF Action	When selected, always occurs immediately
				after detection of a critical event, and is
				stopped after the de-assertion of all critical
				events that requested LED blinking.
Identification LED action	10	No	OEM PEF Action	When selected, always occurs immediately
				after detection of a critical event.

5.3.18.2Alert over LAN

LAN alerts are sent as SNMP traps in ASF formatted Platform Event Traps (PET) to a specified alert destination. The Alert over LAN feature is used to send either PET alerts or directed events to a remote system management application, regardless of the state of the host’s operating system.

LAN alerts may be sent over any of the LAN channels supported by a platform. LAN alerts can be used by PEF to send out alerts to selected destination whenever an event matches an event filter table entry. For more information on LAN alerts, see the IPMI specifications v1.5

5.3.19mBMC Sensor Support

The following tables are for the built-in and the external sensors for the platform. There is a management controller locator record as a built-in SDR besides the given below.

Revision 1.0	137
	C78844-002