Intel SE7520JR2 manual Jumper Blocks, Jumper Block Definitions, Revision 201 C78844-002, Settings

Intel® Server Board SE7520JR2 Connectors and Jumper Blocks

7.8Jumper Blocks

The baseboard has several jumper blocks used to configure or enable/disable various features. This section describes the usage and settings of each.

Table 111: Jumper Block Definitions

Reference	Name	Description
ID
J1H2 (A)	CMOS Clear	Clears CMOS settings
J1H2 (B)	BIOS	Forces the system to boot into BIOS
	Recovery Boot	Recovery mode. A bootable Recovery
		BIOS Floppy disk must be in Drive A for
		this operation.
J1H2 (C)	Password	Clears Administrator and User
	Clear	passwords as set in BIOS Setup
J1A4	Rolling BIOS	Sets the BIOS flash device to boot from
	Configuration	either the upper or lower banks of the
		flash device.
J7A1	Serial B	Configures Pin 7 of the RJ45 Serial B
	Configuration	port to support either a DCD or DSR
		signal

Settings

CMOS Clear by BMC – Pins 1-2 (Default) CMOS Clear Force Erase – Pins 2-3 Normal Boot - Pins 1-2 (Default) Enabled – Pins 2-3

Password Clr Protect – Pins 1-2 (Default) Password Clr Erase – Pins 2-3 Normal Operation – Pins 1-2 (Default) Force to lower bank – Pins 2-3

DCD Select –Pins 1-3

DSR Select – Pins 2-4 (Default)

C

B A

J1H2

CMOS Clear

BIOS Recovery Boot

Password Clear

1 2 3

Figure 26. System Configuration (J1H2) Jumper Block Settings

Revision 1.0	201
	C78844-002