Intel SE7520JR2 C78844-002, Error Reporting and Handling, Intel® Server Board SE7520JR2, Table 62: Virus Related BIOS Messages, Table 63: System Configuration BIOS Messages

	Error Reporting and Handling			Intel® Server Board SE7520JR2
	Message Displayed			Description
				when it detects an imminent failure.
				This message can be reported by an ATAPI device using
				the S.M.A.R.T. error reporting standard. S.M.A.R.T.
				failure messages may indicate the need to replace the
				hard disk.
		Table 62: Virus Related BIOS Messages
	Message Displayed			Description
	BootSector Write !!			The BIOS has detected software attempting to write to a
				drive’s boot sector. This is flagged as possible virus
				activity. This message will only be displayed if Virus
				Detection is enabled in AMIBIOS setup.
	VIRUS: Continue (Y/N)?			If the BIOS detects possible virus activity, it will prompt
				the user. This message will only be displayed if Virus
				Detection is enabled in AMIBIOS setup.
		Table 63: System Configuration BIOS Messages
	Message Displayed			Description
	DMA-2 Error			Error initializing secondary DMA controller. This is a fatal
				error, often indication a problem with system hardware.
	DMA Controller Error			POST error while trying to initialize the DMA controller.
				This is a fatal error, often indication a problem with
				system hardware.
	Checking NVRAM..Update Failed			BIOS could not write to the NVRAM block. This message
				appears when the FLASH part is write-protected or if
				there is no FLASH part (System uses a PROM or
				EPROM).
	Microcode Error			BIOS could not find or load the CPU Microcode Update
				to the CPU. This message only applies to INTEL CPUs.
				The message is most likely to appear when a brand new
				CPU is installed in a motherboard with an outdated
				BIOS. In this case, the BIOS must be updated to include
				the Microcode Update for the new CPU.
	NVRAM Checksum Bad, NVRAM Cleared			There was an error in while validating the NVRAM data.
				This causes POST to clear the NVRAM data.
	Resource Conflict			More than one system device is trying to use the same
				non-shareable resources (Memory or I/O).
	NVRAM Ignored			The NVRAM data used to store Plug’n’Play (PnP) data
				was not used for system configuration in POST.
	NVRAM Bad			The NVRAM data used to store Plug’n’Play (PnP) data
				was not used for system configuration in POST due to a
				data error.
	Static Resource Conflict			Two or more Static Devices are trying to use the same
				resource space (usually Memory or I/O).
	PCI I/O conflict			A PCI adapter generated an I/O resource conflict when
				configured by BIOS POST.
	PCI ROM conflict			A PCI adapter generated an I/O resource conflict when
				configured by BIOS POST.
	PCI IRQ conflict			A PCI adapter generated an I/O resource conflict when
				configured by BIOS POST.
	PCI IRQ routing table error			BIOS POST (DIM code) found a PCI device in the
				system but was unable to figure out how to route an IRQ
				to the device. Usually this error is causing by an
				incomplete description of the PCI Interrupt Routing of the
				system.
	Timer Error			Indicates an error while programming the count register
160				Revision 1.0
			C78844-002