Chapter 2 — Configuring the CK30
2Press Enter to exit and save your changes through a cold boot. Press Esc to exit without saving your changes through a cold boot.
Configuring the CK30 by Scanning Bar Codes
You can change some of the configuration parameters of the CK30 by scanning Code 39 or Code 93 bar code labels containing configuration commands. This method is a fast and easy way to change just a few configuration parameters on a single CK30.
You can only change some of the configuration parameters by scanning bar codes. To configure all of the configuration parameters, use the Configuration Utility or send commands through the network to your CK30.
You can print and scan the bar code labels from the CK30 Command Reference Manual or you can create your own bar code labels. For help, see the CK30 Command Reference Manual.
You can also use Intermec’s EasySet software to print configuration labels you can scan to change your configuration settings. For more information, see the EasySet online help. EasySet is available from the Intermec Data Capture web site.
For example, you can use the Beeper Volume configuration command to adjust the beep volume of the CK30. Scan this bar code label to set the volume to the lowest (quietest) level:
Beeper Volume Low
*$+BV1*
*$+BV1*
34 | CK30 Handheld Computer User’s Manual |
