
Chapter 2 — Configuring the CK30
Configuring 802.11b/g Radio Communications
Make sure all components with antennas are at least 30 cm (1 ft) apart when power is applied. Failure to comply could result in equipment damage.
Attention:
The wireless CK30 has an internal 802.11b/g radio to transfer data using wireless communications. This section of the manual assumes that you have already set up your wireless communications network including your access points. If you are using a UDP Plus network, you also need to have your Intermec Gateway or DCS 30X communicating with a host computer.
Your CK30 supports these network protocols:
•TCP/IP
•UDP Plus
The next sections explain the parameters you need to configure for the CK30 to work in your wireless network.
Configuring the Network Parameters for a TCP/IP Network
In a TCP/IP network, the CK30 communicates with a host computer directly using TCP/IP. The access point acts as a bridge to allow communications between the wired network and the wireless network.
CK30 Handheld Computer User’s Manual | 41 |