Juniper Networks J-Series manual Filtering Command Output, PPPoE, Show services rpm probe-results

Chapter 7: Monitoring the Router and Routing Operations

Table 47: J-Web Monitor Options and Corresponding CLI show Commands (continued)

Monitor Option	Function
DHCP	Displays DHCP dynamic and static leases, conflicts, pools, and
	statistics.
	For details, see “Monitoring DHCP” on page 143.

Corresponding CLI Commands

■show system services dhcp binding

■show system services dhcp conflict

■show system services dhcp pool

■show system services dhcp statistics

RPM	Displays probe results for all RPM probes configured on the
	Services Router, including the round–trip times, jitter, and loss
	percentage of probes sent. Additionally, the RPM monitoring page
	displays a graph that plots the probe results as a function of time.
	For details, see “Monitoring RPM Probes” on page 145.
PPPoE	Displays the following PPPoE information:
	■ PPPoE Interfaces—Session-specific information about the
	interfaces on which PPPoE is enabled.
	■ PPPoE Statistics—Statistics for PPPoE sessions currently
	active.
	■ PPPoE Version—Information about the PPPoE protocol
	currently configured on the router.
	For details, see “Monitoring PPPoE” on page 148.

Media Gateway Displays the following TGM550 Media Gateway information:

■Dynamic Call Admission Control Information—Displays maximum bandwidth available for voice traffic and the dynamic call admission control (CAC) properties configured on the router WAN interfaces.

■Telephony Gateway Module Information—Displays information about TGM550 connectivity and digital signal processor (DSP) capacity.

■Telephony Interface Module Information—Displays the online and offline status of telephony interface modules (TIMs) installed in a J-series router.

For details, see “Monitoring the TGM550 Media Gateway (VoIP)” on page 151.

show services rpm probe-results

■PPPoE interfaces—show pppoe interfaces

■PPPoE statistics—show pppoe statistics

■PPPoE version—show pppoe version

■Dynamic call admission control information—show tgm dynamic-call-admission-control

■Telephony Gateway Module information—show tgm fpc slot-numbermedia-gateway-controllerand show tgm fpc slot-numberdsp-capacity

■Telephony Gateway Module status—show tgm telephony-interface-module status

Filtering Command Output

For operational commands that display output, such as the show commands, you can redirect the output into a filter or a file. When you display help about these commands, one of the options listed is , called a pipe, which allows you to filter the command output.

For example, if you enter the show configuration command, the complete Services Router configuration is displayed on the screen. To limit the display to only those

Monitoring Overview ■ 105