Juniper Networks J-Series Web Ping Mpls Results and Output Summary, Field Description, Time

J-series™ Services Router Administration Guide

Table 110: J-Web Ping MPLS Field Summary (continued)

Field	Function	Your Action
Source Address	Specifies the source address of the ping request	Type the source IP address—a valid address
	packet.	configured on a Services Router interface.
Count	Specifies the number of ping requests to send.	From the list, select the number of ping requests to
		send.
Detailed Output	Requests the display of extensive rather than brief	Select the check box to display detailed output.
	ping output.

Ping MPLS Results and Output

Table 111 on page 222 summarizes the output in the ping MPLS display. If the Services Router receives no responses from the destination host, review the list after Table 111 on page 222 for a possible explanation.

Table 111: J-Web Ping MPLS Results and Output Summary

Field	Description
Exclamation point (!)	Echo reply was received.
Period (.)	Echo reply was not received within the timeout period.
x	Echo reply was received with an error code. Errored packets are not counted in the
	received packets count and are accounted for separately.
number packets transmitted	number—Number of ping requests (probes) sent to a host.
number packets received	number—Number of ping responses received from a host.
percentage packet loss	percentage—Number of ping responses divided by the number of ping requests,
	specified as a percentage.
time	For Layer 2 circuits only, the number of milliseconds required for the ping packet to
	reach the destination. This value is approximate, because the packet has to reach the
	Routing Engine.

If the Services Router does not receive ping responses from the destination host (the output shows a packet loss of 100 percent), one of the following explanations might apply:

222■ Checking MPLS Connections from the J-Web Interface