Juniper Networks J-Series manual Click OK, Snapshot Summary

Chapter 10: Performing Software Upgrades and Reboots

Figure 16 on page 187 shows the Snapshot page.

Figure 16: Snapshot Page

ERROR: Unresolved graphic fileref="s020261.gif" not found in "\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".

To create a boot device:

1.In the J-Web interface, select Manage>Snapshot.

2.On the Snapshot page, enter information into the fields described in Table 97 on page 187.

3.Click Snapshot.

4.Click OK.

Table 97: Snapshot Summary

Field	Function
Target Media	Specifies the boot device to copy the snapshot
	to.
	NOTE: You cannot copy software to the active
	boot device.

Factory	Copies only default files that were loaded on the
	internal compact flash when it was shipped from
	the factory, plus the rescue configuration, if one
	has been set.
	NOTE: After a boot device is created with the
	default factory configuration, it can operate only
	in an internal compact flash slot.
Partition	Partitions the medium. This process is usually
	necessary for boot devices that do not already
	have software installed on them.

Your Action

In the list, select a boot device that is not the active boot device:

■compact-flash—Copies software to the internal compact flash.

■removable-compact-flash—Copies software to the external compact flash. This option is available on J2320, J2350, J4300, and J6300 Services Routers only.

■usb—Copies software to the device connected to the USB port.

To copy only the default factory configuration, plus a rescue configuration if one exists, select the check box.

To partition the medium that you are copying the snapshot to, select the check box.

Configuring Boot Devices ■ 187