Juniper Networks J-Series manual RPM Quick Configuration Summary, Performance Probe Owners

J-series™ Services Router Administration Guide

Figure 26: Main Quick Configuration Page for RPM

ERROR: Unresolved graphic fileref="s020257.gif" not found in "\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".

Figure 27: Probe Test Quick Configuration Page for RPM

ERROR: Unresolved graphic fileref="s020258.gif" not found in "\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".

To configure RPM parameters with Quick Configuration:

1.In the J-Web interface, select Configuration>Quick Configuration>Realtime Performance Monitoring.

2.Enter information into the Quick Configuration page for RPM, as described in Table 140 on page 272.

3.From the main RPM Quick Configuration page, click one of the following buttons:

■To apply the configuration and stay on the Quick Configuration RPM page, click Apply.

■To apply the configuration and return to the Quick Configuration main page, click OK.

■To cancel your entries and return to the Quick Configuration RPM page, click Cancel.

4.To check the configuration, see “Verifying an RPM Configuration” on page 285.

Table 140: RPM Quick Configuration Summary

Field	Function	Your Action
Performance Probe Owners
Owner Name	Identifies an RPM owner for which one or more RPM	Type the name of the RPM owner.
(required)	tests are configured. In most implementations, the
	owner name identifies a network on which a set of
	tests is being run (a particular customer, for example).
Identification
Test name (required)	Uniquely identifies the RPM test	Type the name of the RPM test.
Target (Address or	IP address or URL of probe target	Type the IP address, in dotted decimal
URL) (required)		notation, or the URL of the probe target. If the
		target is a URL, type a fully formed URL that
		includes http://.

Source Address	Explicitly configured IP address to be used as the
	probe source address

Type the source address to be used for the probe. If the source IP address is not one of the router's assigned addresses, the packet uses the outgoing interface's address as its source.

272■ Configuring RPM with Quick Configuration