Juniper Networks J-Series manual User@host show configuration match address

J-series™ Services Router Administration Guide

lines of the configuration that contain address, issue the show configuration command using a pipe into the match filter:

user@host> show configuration match address

address-range low 192.168.3.2 high 192.168.3.254; address-range low 192.168.71.71 high 192.168.71.254; address 192.168.71.70/21;

address 192.168.2.1/24; address 127.0.0.1/32;

For a complete list of the filters, type a command, followed by the pipe, followed by a question mark (?):

user@host> show configuration ?

Possible completions:
compare	Compare configuration	changes with prior version
count	Count occurrences
display	Show additional kinds	of information
except	Show only text that does not match a pattern
find	Search for first occurrence of pattern
hold	Hold text without exiting the --More-- prompt
last	Display end of output	only
match	Show only text that matches a pattern
no-more	Don't paginate output
request	Make system-level requests
resolve	Resolve IP addresses
save	Save output text to file
trim	Trim specified number	of columns from start of line

You can specify complex expressions as an option for the match and except filters. For more information about command output filtering and creating match expressions, see the JUNOS CLI User Guide.

NOTE: To filter the output of configuration mode commands, use the filter commands provided for the operational mode commands. In configuration mode, an additional filter is supported. See the J-series Services Router Basic LAN and WAN Access Configuration Guide.

Before You Begin

To use the J-Web interface and CLI operational tools, you must have the appropriate access privileges. For more information about configuring access privilege levels, see “Adding New Users” on page 11 and the JUNOS System Basics Configuration Guide.

106■ Before You Begin