J-series™ Services Router Administration Guide

Table 89: Interface Alarm Conditions

Interface

Alarm Condition

Description

Configuration

 

 

 

Option

DS1 (T1)

Alarm indication signal

The normal T1 traffic signal contained a defect

ais

 

 

condition and has been replaced by the AIS. A

 

 

 

transmission interruption occurred at the remote

 

 

 

endpoint or upstream of the remote endpoint. This

 

 

 

all-ones signal is transmitted to prevent

 

 

 

consequential downstream failures or alarms.

 

 

Yellow alarm

The remote endpoint is in red alarm failure. This

ylw

 

 

condition is also known as a far end alarm failure.

 

Ethernet

Link is down

The physical link is unavailable.

link-down

Integrated

Hardware or software failure

On the adaptive services module, either the

failure

services

 

hardware associated with the module, or the

 

 

 

software that drives the module, has failed.

 

Serial

Clear-to-Send signal absent

The remote endpoint of the serial link is not

cts-absent

 

 

transmitting a CTS signal. The CTS signal must be

 

 

 

present before data can be transmitted across a

 

 

 

serial link.

 

 

Data Carrier Detect signal

The remote endpoint of the serial link is not

dcd-absent

 

absent

transmitting a DCD signal. Because the DCD signal

 

 

 

transmits the state of the router, no signal probably

 

 

 

indicates that the remote endpoint of the serial link

 

 

 

is unavailable.

 

 

Data Set Ready signal absent

The remote endpoint of the serial link is not

dsr-absent

 

 

transmitting a DSR signal. The DSR signal indicates

 

 

 

that the remote endpoint is ready to receive and

 

 

 

transmit data across the serial link.

 

 

Loss of receive clock

The clock signal from the remote endpoint is not

loss-of-rx-clock

 

 

present. Serial connections require clock signals to

 

 

 

be transmitted from one endpoint and received by

 

 

 

the other endpoint of the link.

 

 

Loss of transmit clock

The local clock signal is not present. Serial

loss-of-tx-clock

 

 

connections require clock signals to be transmitted

 

 

 

from one endpoint and received by the other

 

 

 

endpoint of the link.

 

168Alarm Overview

Page 190
Image 190
Juniper Networks J-Series manual Interface Alarm Conditions