Juniper Networks J-Series manual Configuring TCP and UDP Probes

Chapter 14: Configuring RPM Probes

Table 141: Configuring Basic RPM Probes (continued)

Task

Configure the RPM test http-testfor the RPM owner customerB.

The sample RPM test is an HTTP probe with a test interval (probe frequency) of 30 seconds, a probe type of http-get, and a target URL of http://customerB.net.

J-Web Configuration Editor

1.On the Rpm page, select customerB.

2.In the Test box, click Add new entry.

3.In the Name box, type http-test.

4.In the Test interval box, type 30.

5.In the Probe type box, select http-get.

6.In the Target box, select the Yes check box, and click Configure.

7.In the Target type box, select Url.

8.In the Url box, type http://customerB.net.

9.Click OK.

CLI Configuration Editor

1.From the [edit] hierarchy level, enter

edit services rpm probe customerB

2.Enter

set test http-test probe-frequency 30

3.Enter

set test http-test probe-type http-get

4.Enter

set test http-test target url http://customerB.net

Configure RPM thresholds and corresponding SNMP traps to catch 3 or more successive lost probes and total lost probes of 10 or more.

1.On the Probe page, select http-test.

2.In the Thresholds box, select the Yes check box, and click Configure.

3.In the Successive loss box, type 3.

4.In the Total loss box, type 10.

5.Click OK.

6.In the Traps box, click Add new entry.

7.In the Value box, select probe-failure.

8.Click OK.

9.In the Traps box, click Add new entry.

10.In the Value box, select test-failure.

11.Click OK.

1.Enter

set probe customerB test icmp-test thresholds successive-loss 3

2.Enter

set probe customerB test icmp-test thresholds total-loss 10

3.Enter

set probe customerB test icmp-test traps probe-failure

4.Enter

set probe customerB test icmp-test traps test-failure

Configuring TCP and UDP Probes

To configure RPM using TCP and UDP probes, in addition to the basic RPM properties, you must configure both the host Services Router and the remote Services Router to act as TCP and UDP servers.

If you are using class of service (CoS) and want to classify probes, you must also set a destination interface. The destination interface is the output interface for sending

Configuring RPM with a Configuration Editor ■ 279