Juniper Networks J-Series manual Tuning RPM Probes, CustomerA, Set probe-limit

J-series™ Services Router Administration Guide

Table 142: Configuring TCP and UDP Probes (continued)

Task

Configure Router B to act as a UDP server, using port 50037 to send and receive UDP probes.

J-Web Configuration Editor		CLI Configuration Editor
1.	Next to Probe server, click Edit.	Enter
2.	In the Udp box, click Configure.	set probe-server udp port 50037

3.In the Port box, type 50037.

4.Click OK.

Tuning RPM Probes

After configuring an RPM probe, you can set parameters to control probe functions, such as the interval between probes, the total number of concurrent probes that a system can handle, and the source address used for each probe packet. This example tunes the ICMP probe set for customer A in “Configuring Basic RPM

Probes” on page 276.

To configure tune RPM probes:

1.Perform the configuration tasks described in Table 141 on page 277.

2.Navigate to the top of the configuration hierarchy in either the J-Web or CLI configuration editor.

3.Perform the configuration tasks described in Table 143 on page 282.

4.If you are finished configuring the network, commit the configuration.

5.To check the configuration, see “Verifying an RPM Configuration” on page 285.

Table 143: Tuning RPM Probes

Task	J-Web Configuration Editor
Navigate to the Services>RPM level in	1.	In the J-Web interface, select
the configuration hierarchy.		Configuration>View and
		Edit>Edit Configuration.
	2.	Next to Services, click Configure
		or Edit.
	3.	Next to Rpm, select the Yes check
		box.
	4.	Click Edit.

CLI Configuration Editor

From the [edit] hierarchy level, enter

edit services rpm

Set the maximum number of concurrent	1.	In the Probe limit box, type 10.
probes allowed on the system to 10.	2.	Click OK.
Access the ICMP probe of customer A.	1.	In the Owner box, click
		CustomerA.
	2.	In the Name box, click icmp-test.

Enter

set probe-limit 10

From the [edit] hierarchy level, enter

edit services rpm probe customerA test icmp-test

282■ Configuring RPM with a Configuration Editor