Juniper Networks J-Series Monitoring DLSw Routing Information, RIP Neighbors, DLSw Capabilities

Chapter 7: Monitoring the Router and Routing Operations

Table 55: Summary of Key RIP Routing Output Fields (continued)

Field	Values	Additional Information
Routes	Number of RIP routes advertised on the logical
advertised	interface.
RIP Neighbors
Neighbor	Name of the RIP neighbor.	This value is the name of the interface on which RIP
		is enabled. The name is set in either of the following
		ways:
		■ In the J-Web configuration editor, on the
		Protocols>RIP>Group> group-name>Neighbor
		page
		■ In the CLI configuration editor, with the neighbor
		neighbor-namestatement at the [edit protocols rip
		group group-name]level of the configuration
		hierarchy
State	State of the RIP connection: Up or Dn (Down).
Source	Local source address.	This value is the configured address of the interface on
Address		which RIP is enabled.
Destination	Destination address.	This value is the configured address of the immediate
Address		RIP adjacency.
In Met	Value of the incoming metric configured for the RIP
	neighbor.

Monitoring DLSw Routing Information

To view DLSw routing information, select Monitor>Routing>DLSw Information, or enter the following CLI commands:

■show dlsw capabilities

■show dlsw circuits

■show dlsw peers

■show dlsw reachability

Table 56 on page 121 summarizes key routing information output fields in the DLSw routing display.

Table 56: Summary of Key DLSw Routing Information Output Fields

Field	Values	Additional Information
DLSw Capabilities
Peer	IP address of the peer DLSw router
Vendor ID	Numerical value assigned to Juniper Networks.

Using the Monitoring Tools ■ 121