Configuring the System for SpectraLink NetLink Telephones
SpectraLink NetLink Telephones require an extra Operating System configuration step to optimize integration with Operating System. That configuration step is to enable long preambles in the Operating System:
•Using the Command Line Interface
•Using the Web User Interface
•Using the Cisco Wireless Control System
Using the Command Line Interface
Use this procedure to optimize the Operating System to communicate with SpectraLink NetLink Telephones using a long preamble.
•Log into the command line interface as described in Logging Into the CLI.
•Use the show 802.11b command to view the following parameter:
Short Preamble mandatory | Enabled |
which shows the Operating System default, Short Preamble Enabled; if this is the case, continue with this procedure.
If this parameter indicates Short Preamble Disabled, this Cisco Wireless LAN Controller is already optimized for SpectraLink NetLink Telephones; if desired, continue with the Product Guide.
•Disable the 802.11b/g network using the config 802.11b disable network command.
•Enable long preambles using the config 802.11b preamble long command.
•Enable the 802.11b/g network using the config 802.11b enable network command.
•Reboot the Cisco Wireless LAN Controller using the reset system command.
Answer y to the The system has unsaved changes. Would you like to save them now? (y/n) prompt.
•The Cisco Wireless LAN Controller reboots.
•Verify that the Cisco Wireless LAN Controller is properly configured by logging back into the CLI and using the show 802.11b command to view the following parameters:
802.11b Network | Enabled |
Short Preamble mandatory | Disabled |
which shows that the 802.11b/g Network is Enabled and the Short Preamble is Disabled (Long Preamble is Enabled).
•This Cisco Wireless LAN Controller is now optimized for SpectraLink NetLink Telephones; if desired, continue with the Product Guide.
Using the Web User Interface
Use this procedure to optimize the Operating System to communicate with SpectraLink NetLink Telephones using a long preamble.
•Log into the Web User Interface as described in Using the Web User Interface.
•Use Wireless / Global RF / 802.11b/g Network to view the 802.11b/g Global Parameters page.
5/26/05 | Configuring the System for SpectraLink NetLink Telephones |
|
