FCC Statements for Cisco 1000 Series Lightweight Access Points
This section includes the following FCC statements for Cisco 1000 Series lightweight access points:
•Class A Statement
•RF Radiation Hazard Warning
•
•Deployment Statement
Class A Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
RF Radiation Hazard Warning
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the antenna of the device will be greater than 20 cm (8 in.) from all persons. Using higher gain antennas and types of antennas not covered under the FCC certification of this product is not allowed.
Installers of the radio and end users of the Cisco Wireless LAN Solution must adhere to the installation instructions provided in this manual.
Non-Modification Statement
Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unautho- rized antennas, modifications, or attachments could damage the badge and could violate FCC regulations and void the user’s authority to operate the equipment.
Note: Refer to the Cisco WLAN Solution Release Notes for 802.11a external antenna information. Contact Cisco for a list of
Deployment Statement
This product is certified for indoor deployment only. Do not install or use this product outdoors.
5/26/05 FCC Statements for Cisco 1000 Series Lightweight Access Points
