JVC UX-J99DVD Connecting Other Equipment, Getting Started Continued, English, Color system of TV

English

Getting Started (Continued)

To select the color system

You need to select the color system setting of this unit to match to your TV.

Set the NTSC/PAL switch on the rear correctly while in standby mode by referring to the table below.

AUDIO		COMPONENT			ANTENNA
PCM	OPTICAL	PR	PBY
	DIGITAL
	IN				NTSC
PCM/	DVD OPTICAL	S-VIDEO	VIDEO	VIDEO
STREAM	DIGITAL
	OUT			OUT
RIGHT	LEFT				PAL
SPEAKER	SPEAKERS
IMPEDANCE
4Ω ~ 16Ω		AV			VIDEO OUT
		COMPU LINK
		NTSC			SELECT
		PAL
RIGHT LEFT		VIDEO OUT

AUDIO

PCM OPTICAL

DIGITAL

IN

PCM/ DVD OPTICAL

STREAM DIGITAL

OUT

RIGHTLEFT

Before connecting an optical digital cord, unplug the protective plug.

SELECT

Color system of TV	Color system setting
Multi-color system	PAL or NTSC*
PAL	PAL
NTSC	NTSC

* Set the color system of the unit and TV to match the system of

the playback disc.

To optical digital input

Optical digital cord (not supplied)

To optical digital output

Audio equipment with an optical digital input

Audio equipment with an optical digital output

• Before playing back a disc, it is also required to select the correct

“MONITOR TYPE” in the PICTURE menu according to the

aspect ratio of your TV. (See page 78.)

If you play back an NTSC disc with this setting set to “PAL”

You can watch the playback pictures (the disc will be reproduced using “PAL 60” format), but the TV screen may roll upward and downward rapidly.

If you play back a PAL disc with this setting set to “NTSC”

You can watch the playback, but the following symptoms may occur:

•The items on the disc menu will be blurred, and be shown slightly shifted when highlighted.

•The aspect ratio of the picture may differ from the original aspect ratio.

•The picture movement is not smooth.

Connecting Other Equipment

You can connect other equipment such as a digital decoder to reproduce multi-channel sounds or audio equipment which can be used as a playback device.

When you connect and use such equipment, refer also to its manual.

•DO NOT connect other equipment while the

power is on.

•DO NOT plug in any equipment until all connections are complete.

To connect audio equipment with an optical digital input/ output terminal—such as portable MD recorder

By using an optical digital cord (not supplied), you can connect audio equipment with an optical digital input/output terminal.

•Before playing back a disc, select “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu according to audio equipment connected to the DVD OPTICAL DIGITAL OUT terminal. (See page 79.)

To connect analog audio equipment

By using an RCA pin plug cord (not supplied), you can connect equipment with analog audio output jacks such as an MD player, a TV, etc.

•Be sure that the plugs of the audio cords and the jacks on the rear of the unit are color-coded:

White plugs and jacks are for left audio signals, and red ones for right audio signals.

AUDIO
PCM	OPTICAL
	DIGITAL		MD player, TV, etc.
	IN
PCM/	DVD OPTICAL	To analog
STREAM	DIGITAL	audio output
	OUT
			Right	Left
RIGHT	LEFT		RCA pin
	Left		plug cord
	Right

To listen to or to record the sound from analog audio equipment connected to the AUX jacks, select “AUX” as the source to play. (See page 44.)

NOW you are ready to plug in the unit and any other connected equipment.

IMPORTANT:

Be sure to check that all connections have been made before plugging in the power cord.

9