67
DiskGlobalSamplingCombinationProgram
Other functionality
Program mode
An “Auto Sampling Setup” page menu command has been
added to the Program P0: Sampling page.

0–3E: Auto Sampling Setup

This convenient command automatically sets sampling-
related parameters of Program mode to the optimal settings
for specific operations. (For the automatically-set parame-
ters and their values, ☞p.69)
When you execute this command, the applicable
parameters will be set automatically. You cannot use the
[COMPARE] key to recall the previous settings.
The settings are automatically made for the most typi-
cal applications. After executing the auto setup opera-
tion, you can further adjust any of the settings to suit
your needs as described in the paragraphs of each
section.
1. Initialize
This sets sampling-related parameters to their default state.
1Select “Auto Sampling Setup” to open the dialog box.
2Use the radio buttons to select Initialize.
3Press the OK button to execute “Auto Sampling Setup.”
If you decide to cancel, press the Cancel button. (For the
automatically-set parameters and their values, ☞p.69)

2. Resample Program Play

This automatically makes the appropriate settings so you
can play a program and resample your performance.
■
Setup
1Select “Auto Sampling Setup” to open the dialog box.
2Use the radio buttons to select Resample Program Play.
3Use “Save to” to specify the destination to which the res-
ampled data will be written. (☞PG p.5 “Save to”)
RAM: The resampled data will be written into sample
memory (RAM). If the “Convert to Program” option in
step 4 is checked, a new multisample will automatically
be created after resampling.
DISK: A WAVE file will be created for the resampled
data and saved on the internal hard drive or an external
SCSI hard drive.
4If you select “Save to: RAM” and check “Convert to Pro-
gram,” the resampled data will be converted into a pro-
gram using the number you specify in “Program.” You
can then move to Program mode after resampling and
play the data immediately.
5Use “Program” to specify the program where the con-
verted data will be saved.
6Press the OK button to execute “Auto Sampling Setup.”
If you decide not to execute, press the Cancel button.
(For the automatically-set parameters and their values,
☞p.69. For examples of using the automatically-set
parameters, refer to ☞BG p.45)
If you selected “Save to: RAM” and want to change the
RAM bank, use the page menu command “Select Bank
& Smpl No.” (0–3C ☞PG p.6) to specify the resam-
pling-destination sample memory (RAM).
If you selected “Save to: DISK,” use the page menu
command “Select Directory” (0–3D ☞PG p.7) to spec-
ify the save-destination for the WAVE file that will be
created by resampling.
■
Resample
7Press the SAMPLING [REC] key and then the SAM-
PLING [START/STOP] key.
8Play the keyboard etc. Sampling will begin at the first
note-on. (☞PG p.4)
9When you have finished playing, press the SAMPLING
[START/STOP] key.
If you have selected “Save to: RAM” (Convert to Pro-
gram) and continue resampling without changing the
settings, the successive samples will automatically be
assigned to C#2, D2, …
Auto Sampling Setup
0–3E