Lanier AP3200 manual OHP Transparencies, Adhesive Labels, Envelopes

Paper and Other Media Supported by This Printer

❖OHP Transparencies

•If you load OHP transparencies into tray 2, switch the lever inside of the paper tray to "Non-Standard Paper" mode. ⇒ P.34 “Loading Thick Paper, Envelopes or OHP Transparencies”

•Be careful not to touch the print side of the OHP transparencies or the print side can become dirty or damaged, resulting in poor print quality.

•If you print on an OHP transparency that has a print side, load it face up into tray 2 or load it face down into Bypass Tray Type 270.

•Do not print on OHP transparencies for color.

❖ Adhesive Labels 3

•Load only one adhesive label at a time into Bypass Tray Type 270.

•Use adhesive labels in which the whole side can be printed on.

•Avoid using adhesive labels having exposed glue.

•If the print side is coated, the print quality might be reduced, as the toner might not fuse well.

❖Envelopes

•When printing on envelopes, use tray 2 or Bypass Tray Type 270.

•If you load envelopes into tray 2, switch the lever inside of the paper tray to “Non-Standard Paper” mode. ⇒ P.34 “Loading Thick Paper, Envelopes or OHP Transparencies”

•You can select the sizes for the envelopes using the operation panel.

⇒ P.99 “Job Control Parameters”

•Recommended of envelopes is as follows:

• Com#10 Env

• C6 Env

• C5 Env

• DL Env

• Monarch Env

•Do not stack envelopes over the limit mark.

•Confirm that print side is facing up when loading into the tray 2.

•Confirm that print side is facing down when loading into Bypass Tray Type 270.

•Load the envelopes with the flaps aligned to the right side fence. The flaps should be securely folded down.

•Confirm that there is no air in the envelopes before loading.

•To get better print quality, it is recommended that you set the right, left, top, and bottom print margins, to at least 15 mm (0.6") each.

•Do not print on both sides of envelopes.

27